Orbit500V2 Gearbox 4:1

Quantity:
Payment methods:
  • Pay with PayPal

Related products


This product is designed to be used with 500 series motors, like as: RS-540, RS-545, RS-550, RS-555 or similar. See above on "Related Products" section motors compatible with the gearbox we have in our store.

The new line of planetary gearboxes Orbit500-V2 came to add several improvements to the original project.
Like those:
- Double bearing on the output shaft, providing much more rigidity and load support.
- Shaft with keyway and central threaded hole, better fixation of components.
- Ventilation Channel in the Motor Block, longer life for your electric motor.
- Assembly with 4 Allen screws, making the set more solid.
- New Hardened gears, greater strength, and more durability.

Due to its small size, this set is perfect for creating compact prototypes.
Its use extends, but is not limited to: Robots for: Hockey, Sumo (RC and Auto), Trekking-Pro, Combat Robots and others... Just choose your reduction ratio (4X, 16X, 64X or 256X) and hands to work!

If you want to modify or customize your reduction, this is also very easy! Orbit500-V2 stages are interchangeable and "plug an play". Just remove or add a stage to change the ratio.

Content and Technical Data
  • This Kit Contains:
  • 1Planetary gearbox 4:1
  • 1Pinion for 1/8" shaft (3,175mm)*
  • 2M3 x 8mm screws
  • 2M3 Pressure Washers
Type of reduction: Planetary
Ratio: 4:1 - 1 Stage
Efficiency: 0.96 ~ 0.98
Maximum Output Torque: 375 kgf.cm
Output Shaft Diameter: 8mm
Shaft Fitting Type: 3mm keyway with M3 thread on the tip
Width/Height (Square): 38mm (1.5")
Gearbox Length: 37,5mm
Shaft Length: 26mm
Assembly Points: 8 holes with M4 thread
Gear Module: 0,6
Gear Material: SMF5040 Steel (30-40 HRC hardness)
Block Material: Zamak-5, Zinc plated
Set Weight: 218g

Input MotorsOutput RotationMaximum Performance Torque Stall Torque
AK-555 12V 6500 RPM1625 RPM1,2 kgf.cm6,8 kgf.cm
RS-555 12V 8000 RPM2000 RPM0,9 kgf.cm7,4 kgf.cm
AK-555 12V 18200 RPM4550 RPM1,6 kgf.cm5,2 kgf.cm

IMPORTANT:

*For the Pinion assembly on your electric motor, ensure that the shaft is supported and touching the base. Press the gear with the aid of a small manual press.
The distance from the gear to the face of the motor must be 9.5mm or less.
See the Technical Drawing of Components to understand this procedure.
Also, be careful to not mount the pinion out of place, use some base or guide to ensure parallelism


**After assembling the electric motor, it is recommended to smooth the gearbox.
Let the set run for a few minutes to the right and then to the left. This will improve performance.


DOCUMENTATION


To make comments you must be logged in. Login.

You are not registered yet? Register Now!