The Dino V2 is the new version of the renowned controller Dino. It is a two-motor controller optimized for use with radio control and its receivers. This board is suitable for small and mini (antweight) robots, mini remote control cars and other models.
With this electronics it is possible to control two brushed DC motors, each up to 1.1A continuous. The peak current is 2.8A for a few seconds. This board has thermal protection, which means that you won't have to worry about burning due to accidental stalls .
It has a 5V BEC, so it can power a microcontroller or the radio control receiver itself via signal cables. It also has an LED to indicate the status of the channels.
Dino now has reverse polarity protection , making it even more robust! In its new version it allows three modes of use:
- Mixed Mode: one of the channels controls the movement of the robot, while the other controls the curves (this mode goes by default on the board, just leave the pads on the back of the board without soldering).
- Tank mode: each channel controls one of the motors, independently (to activate this mode, solder the TANK and CENTRAL pins on the back of the board).
- Mirror mode: the two outputs respond to a single channel, perfect for controlling two motors with just one of the radio sticks (to activate this mode, solder the MIRROR and CENTRAL pins on the back of the board.)
Basic connection example
The card has an LED for status indication:
- Constant on: channels A and B with signal
- Blinking once: channel A with no signal
- Blinking twice: channel B with no signal
- Blinking three times: channels A and B with no signal
- Two independent motor control outputs (or resistive loads up to 1A)
- Supply voltage: 6V to 15V (2S and 3S LiPo batteries)
- Current: 1.1A continuous per channel (2.8A peak)
- BEC voltage: 5V
- BEC current: 150mA
- Input signal: radio control (PPM)
- Control modes: Mixer, Tank and Mirror
- Thermal protection
- Reverse power protection
- Has Fail-Safe: Yes
- Dimensions: 25 x 15mm
- Has welded cables: no, because there is the possibility to use with cables, male or female pin bars
- Weight: 5g
To make comments you must be logged in. Login.
You are not registered yet? Register Now!
lucashudson2002
Sent 2023-06-16 13:44:28
Sent 2023-06-16 13:44:28
Boa tarde! É possível disponibilizar o esquemático e o 3d da placa? Agradeço!
luan.ferreira
Sent 2023-06-16 16:24:38
lucashudson2002
Sent 2023-06-16 16:24:38
lucashudson2002
Olá! Gostaríamos de informar que adicionamos o modelo 3D da placa na descrição do produto. Sendo assim, você já pode usá-lo como referência.
ESGUIMARAES
Sent 2021-10-24 15:29:01
Sent 2021-10-24 15:29:01
bom dia sres Eu comprei o Kit do Tanque e vi no vídeo que tem um produtos interessantes , gostaria que vc fizessem videos de aplicação básica assim desenvolvemos nossos conhecimentos com estes novos produtos. um abraço e fico na espera de novos videos de aplicação
Giovanni5
Sent 2021-10-25 08:05:45
ESGUIMARAES
Sent 2021-10-25 08:05:45
ESGUIMARAES
Agradecemos pela sugestão, iremos avaliar a melhor maneira de gravar o vídeo da aplicação básica. Fique por dentro das nossas redes sociais para ser avisado quando o vídeo estiver disponível para assistir.